I.D. Blasting Equipment

For sandblasting the inside of pipe lengths, Applied has you covered with a selection of tools to retrofit onto your blast hose for blasting the inside surface area of pipes with outstanding results. Our I.D. blasting tools allow the operator to blast the inside area of pipes ranging from 19mm (3/4”) to 305mm (12”) which use a specific design to deflect the abrasive from the tool at a 360⁰ blast pattern. A typical 5m pipe with a diameter of 205mm (12”) would take an operator over 2 hours to blast the internal area of a pipe whereas with an Applied I.D. blasting tool, the same pipe would be completely cleaned in under 30 minutes with an exceptional results and uniformity. For the bigger sized pipes we also stock a fully adjustable centering carriage which allows the operator to mount the blasting tool into and simply wheel the blasting tool into the pipe providing extra uniform coverage.

ID Blasting Equipment | Applied Concepts LTD
ConeBlast Blasting Tool

ConeBlast ½” Blasting Tool

The Applied ConeBlast ½”Blasting tool is specifically designed to produce outstanding blasting results on the internal area of pipework ranging in sizes from 125mm (5”) to 305mm (12”) internal diameter.

ConeBlast Blasting Tool | Applied Concepts LTD

ConeBlast ¼” Blasting Tool

The Applied ConeBlast ¼”Blasting tool is specifically designed to produce outstanding blasting results on the internal area of pipework ranging in sizes from 19mm (3/4”) to 50mm (2”) internal diameter.